hydraulic NC steel bar bending machine

hydraulic NC steel bar bending machine
  • Продавецlevellawns.us
  • Список ценUS $8000.00piece
  • Продажная ценаUS $8000.00piece
  • ДоставкаБесплатная доставка
  • Рейтинги4,3 (403)

Oписание продукта


Brass Bending Machine / Aluminum / Flat Iron / Bending Machine / Manual Bending  Iron Bar

Bending Machine TS-12 10mm thickness


Notice : when the parcel arrived to your customs  ,please pay the           

            tax and pick up the parcel  ,we are not responsible for            

            any customs duty or import tax  

   if your place is remote ,then need to pay 35usd .


Picture showing :


                           Cold drawn round or stainless steel with a diameter of 12mm




Name: Manual bending machine
Model: TS-12
Applicable thickness: 10mm
Maximum bending width: 100mm
Packing size: 25*16*16cm
Weight: 11.5kg

Related parameters:

     Bending width: 100mm

     Bending thickness: 0 ~ 12mm (adjustable, by adjusting the gasket to adjust)

   The maximum thickness and width of a certain relationship.For iron plate:

        0 ~ 4mm thick, foldable around 100mm wide

           5mm thick, folding 70mm wide or so

           6mm thick, folding 50mm wide or so

           7mm thick, folding 40mm wide or so

           8mm thick, folding 30mm wide or so

                   10mm thick, 20mm width can be folded around

        The corresponding width of aluminum row by 2 ~ 2.5, the corresponding increase in the width of copper 1/3 (excluding high-intensity special copper excluded)


Related instructions:

      1. fold relatively thin plate, you can fold a position, without changing the lever position.

      2. For a thicker plate, change the position of the force lever, because when folded to nearly 90 °, the person is forceful at this point.

    Although a bit inconvenient, but still much faster than the hydraulic pressure, hand-cranked hydraulic bending machine, suppressed at least shake 30 a few times.

Note: For the small copper row, the machine has improved pad can be padded to the front, that is, the gap between the platens and flap adjustable to zero, in order to meet the needs of small thin copper bar (previously the minimum gap4mm, fold thin copper gap big point).


Note: This machine without extension pole, you can go to the hardware store to buy two thick 6 iron pipe, the length of 800mm